Heating Element Replacement in Attleboro, MA

Electric tanks heat water with two elements, and when one burns out you get half the hot water — or none at all if both are gone. Mineral scale is the usual killer: it buries the lower element, which overheats and fails. We test each element, drain below the port, and install a correctly rated replacement with a new gasket.

Hard, mineral-rich water is common around Attleboro, and it shortens element life dramatically — we've pulled elements from local heaters caked in an inch of lime scale. In older homes we also check the wiring and breaker sizing while we're in there, because decades of panel changes can leave an electric heater under-protected, which cooks elements prematurely.

How We Handle It

1. Cut power and confirm it's dead, then drain the tank below the element port.
2. Test both elements and thermostats to confirm the element is the true failure.
3. Install the new element with a fresh gasket, torqued to spec — no overtightening.
4. Refill fully before restoring power (dry-firing destroys a new element in seconds), then test.